Submission of paper

Instructions for Paper Preparation and Submission for ICNBME 2011

All documents must be in ".doc" format (Word) ICBNME-2011 Paper format .

1. Abstract

This paper provides an example of the layout and style for the paper submissions for the ICBNME 2011 conference. Paper submission information is also discussed. The abstract should count 250 words and have a structured form, i.e. reflect structure of an article (background, material and methods, results, conclusion). 10 pt size font should be used for the abstract.

2. Introduction

Prospective authors are invited to submit papers that fit within the scope of the electrical section. Papers should be written in English (USA) language and submitted in final camera-ready form.

3. Paper and text format

Contributed papers will be selected on the basis of four - six pages. Papers should be single - spaced on one side only of A4 pages. The margins will be: top 2.0 cm, bottom 2.0 cm, left and right 1.8 cm, gutter 0 cm. For fonts see Table 1. The text should be presented in a two-column format, each one of 8.3 cm in width. The space between columns should be of 0.9 cm. Last page columns should have equal length and occupy at least 60% of the sheet of paper.
Accepted papers will be included in the Conference Proceedings, distributed to the participants at the beginning of the conference.

Table 1. The recommended fonts

Item Font Size Style
Title of paper TN Roman 24 Bold
Authors' names TN Roman 11 Norm
Authors' address TN Roman 11 Ital
Abstract TN Roman 10 Bold
Title of section TN Roman 10 Norm
Text, Formulae TN Roman 10 Norm
Algorithms Courier New 10 Norm
References TNRoman 10 Norm

Note. TN Roman means Times New Roman

The authors' names and affiliation, should appear on separate lines and the mailing address should appear after the author to whom the correspondence will be addressed. Footnotes should be avoided, their contents being integrated into the text.

Tables, figures, equations

Illustrations and tables should be progressively numbered, following the order cited in the text, and may be organised in one or two columns. They should be accompanied by an explanatory text positioned at the top of the tables and at the bottom of the figures.
The large figures may be placed on a single column on the top or the bottom of the page.
The same for drawings, diagrams etc.
Formulae should be clearly written and well separated from the text. Each formula should occupy one line. Consecutive numbers should be marked in brackets.
References to cited sources should be incorporated within the text (e.g. [1]). The bibliographical references should be placed at the end of the paper and should follow the model given below.

4. Conclusions

Instructions for paper preparation and submission were specified. Please check these instructions for possible updates before submitting the final paper.


Appendices, if present, must be marked A, B, C, and placed before Acknowledgment.


Don’t forget to thank to the persons or institution that help you to finish the paper.

[1] G.D. Gristede, Al.E. Ruehli, C.A. Zukowski,  Convergence Properties of Waveform Relaxation Circuit Simulation Methods, IEEE Trans. on Circuits and Systems, vol. 45, no. 7, 1998, pp. 726-738.
[2] L.O. Chua, P.M. Lin, Computer-Aided Analysis of Electronic Circuits: Algorithms and Computational Techniques, Englewood cliffs NJ, Prentice-Hall, 1975.